English
China
faygocn
+86 133 9419 1191
12. Why does the new machine fail to respond after powering on?
【2022-03-21 】 Our machine is equipped with a phase sequence detection device. Please check whether the phase sequence is correct and the neutral wire is connected in place....
13. What is the problem that the machine suddenly does not enter the embryo during production?
【2022-03-21 】 1. Check whether the remote blocking detection switch is normal2. Check whether the photoelectricity of the embryonic path is normal...
14. What kind of oil is generally added for lubrication of the stretch rod? How much do you add each time?
【2022-03-21 】 The stretch rod is in direct contact with the product, and food grade grease must be added for lubrication. Otherwise, it will cause product contamination. Generally, once a week, one layer of oil film is sufficient....
15. What is the purpose of the small blue tube on the linear guide slider?
【2022-03-21 】 That is to facilitate the lubrication of the guide rail. Please lubricate the slider according to the lubrication period table....
16. How to reset the connection position between the opening and closing cam and the electric cylinder because the preform fell off?
【2022-03-21 】 First take out the preform and bottle, then loosen the four screws that fix the connecting seat to make it in a loose state, then push the cam by hand to reset, and then lock the screws after resetting....
17. The position of the embryo feed dial is wrong, and how to adjust the bottle mouth often stuck?
【2022-03-21 】 Loosen the screw on the dial, turn the dial so that the position of the dial coincides with the position of the embryo holder, and then tighten the screw. Put 2~3 preforms in manually, and stop when the preforms enter the gripper. Then gently rotate the preform by hand, and the preform will rotate s...
